REVERSIBLE BONDED STRAIN GAGE

To measure thermal strain, precisely especially with large scale structure, the overview can not be welded using strain gauge, strain gauge, strain gauge to reversible development. Basically, there is a special polyimide strain gauge with the same base side and cover side, so you can use it in both directions. It can be used to measure the structure of aluminum alloys or composites with distortion temperature (482oF) below 250oC (welding difficult gauges). These strain gauges can be peeled off after performing the necessary apparent strain measurement. The furnace can be mounted upside down at the desired location on the structure.

The gauge metal material is formed from a thin foil coating and glued to the plastic that etches the substrate 695. Then, using conventional adhesive 695 which adheres to the substrate beam which is a strain gauge conventional knowledge in the art. The SAW strain gage also has a similar shape. The illustration tank metering system 69 shown in Figure 1 is RMS error of less than 20, typically of 0.1 gallons of fuel tank, and is highly accurate. This corresponds to a travel distance of about 2 to 3 miles, about 3 to 5 kilometers. In many cases, the accuracy of the array is not essential, a simple system as shown in Figure 1. 71 can be used. In this case, the load cell signal is added only in case of Grills et al. Although it is patented, reference quality is not used. In this case, no attempt is made to compensate for the pitch or roll of the vehicle.

When an impact load occurs, it determines the strain of the material by measuring the micro displacement of the beam. Adhesive metal strain gauges are the most common method used to measure deflection. The resistance of these strain gauges changes when deformed by the impact load. Select the strain gauge and the gauge length is the most important consideration since the strain strain gauge to measure the average length. Metal foil strain gauge (SGD-6/120-LY 1130)

As described above, the seat belt 350 can measure the tension without requiring the power line and the signal line. 90. The SAW strain gauge is shown. Figure 90 shows power supply and free wireless passive SAW strain gauge device 357 for this purpose. There are many other places, such as wearing a means to measure belt tension at one such place or several places. In addition, the SAW based accelerometer can be placed on a seat belt near the occupant's chest as a preferred measure of the pressure on the occupant by the seat belt, allowing stress control.