Basic Steps for Throwing on the Wheel

The wedge shaped clay very well forms a sphere. Throw clay at the center of the bat of the steering wheel. Seal the base and make it conical. Center Clay: Leg Support Arm, Wheel Speed ​​Medium Speed. Place your hand around the clay base, squeeze the clay slowly toward the center and taper upwards. Push down the clay: Press the left side of the clay using the heel of the left hand and push the upper part of the right side. Repeat steps 3 and 4 until the clay is at the center. Open the clay. With slow wheels, push the thumbs together into the middle of the clay. Leave ½ / 2 21 clay at the bottom - Measure with a needle tool. Create a floor. Start from the center and draw your right hand finger to the right. For cylinders, keep the floor flat. In the case of a bowl, bend the wall with your finger to draw a curve. Pull the wall: Slow wheel. The left hand is inside and the right hand is outside (3 o'clock). The right hand pushes up the base, moves the clay upward, and goes up to the upper left. Gently squeeze and move your hand up with clay. Please clench the clay. Shape: To make a shape: Press outside slowly on the outside of the finger. Shape: Push up slowly on the outside of the finger. Ribs are refined and smoothed to remove moisture from the surface. 10. End: Crop the edge horizontally. Remove extra clay on the base. In the case of a bowl, leave clay on the foundation to support the wall. Pull down the string at the base. Remember:

• Lower the elbow. • Keep water on the clay and reduce the amount of water used during molding. • Touch your hands and combine them for better control. • Make clay using the whole body and focus on the center. • Always keep hand in and out when the wheel is rotating.

Walk around. The function of the oyster may become a non-uniform pot. • Touch the pot only when the wheel is moving. • The larger the width, the slower you need to do. • Placing clay in the center is the most difficult and most important part of throwing

And do not forget to download the free five pottery throwing techniques if you do not have it: detailed, detailed instructions, nationally renowned ceramist, teacher, and seminar organizer

These instructions will give you the stepwise process of basic pitching. Whatever you want to do, most of the things you do in the pottery begins with the same basic instructions. Once you have completed the basic steps, you can try more complex forms and more clay. The best way to measure if it is in the center is to gently place your hand around the clay and turn the steering wheel. If your hand does not move, that is, there is no movement beneath it, you will be centered. If your hands swing while swinging, you need to flip up and down again

Place the clay in the center of the wheel head. The easiest way is to throw clay in the center. Please rotate the wheel quickly. Fill wet hands and clay with water. The aim here is to hold the clay in your hand, squeeze it with your feet and get extra strength and then pull it to make it a tower type. If you are using a caster, you can control the rotation speed of the clay, but a lot of force is needed. Electric wheels need less energy, but you have less control over speed. At the same time push the clay onto the wheel so that extra clay and water slide off the wheel from the hand. The first thing you have to do is settle clay. From the side, clay balls appear to be uniform and should rotate evenly like the wheel of a car.